Printer Scale

[tbodine88]

  63-2_spreader_Tab_template.dc (Size: 1.68 KB / Downloads: 7) I have been using DeltaCAD for years, since 2000.
I seem to remember that sometime ago that when I printed at scale 1.0, then a one inch square would print out as a one inch square on paper.

Today I find I must print at 0.977 scale to get the same result.

I am using version 8.0
I have a epson ET2760.

I have enclosed a drawing with a ruler. The scale is set so that it prints the ruler at 3".

Is there a way to adjust Delta Cad so that the scale is correct on my printer?

[AlwMVMO]

Have you tried setting your printer to Borderless printing?
The 3 inch scale printed on my Canon MX459 at 1.0 print scale just fine.
You're not the 1st person to have this problem, I just don't have a good answer. 

-----------------------------------------------------------------------------------
DeltaCad (Midnight Software) has a FAQ that has some suggestions at ( DeltaCad FAQ )
You may also have to contact them at ( CONTACT ) to see if they have any more suggestions.
-----------------------------------------------------------------------------------

P.S.
I noticed the lower right corner of your 4.874 x 1.625 part isn't connected.