04-15-2010, 05:49 AM
Hello,
I am a new member living on the Canary Islands. I have been using DeltaCad for years but only in a very basic mode, without using the full capabilities of the program. Now I am learning, or rather relearning what I know 50 years ago, to make technical drawings, using the book "Workshop drawing" by Tubal Cain as a tutor.
DeltaCad makes it very easy to do the drawings in the traditional way with helplines, but the calculator tutorial shows that there are many ways to kill a cat in Deltacad and I feel that I am probably not using the best one.
I would appreciate some advice on the easiest way to do the basic engineering drawing of something where you have three views, from the front, from the top and from the side.
Goran:-/
I am a new member living on the Canary Islands. I have been using DeltaCad for years but only in a very basic mode, without using the full capabilities of the program. Now I am learning, or rather relearning what I know 50 years ago, to make technical drawings, using the book "Workshop drawing" by Tubal Cain as a tutor.
DeltaCad makes it very easy to do the drawings in the traditional way with helplines, but the calculator tutorial shows that there are many ways to kill a cat in Deltacad and I feel that I am probably not using the best one.
I would appreciate some advice on the easiest way to do the basic engineering drawing of something where you have three views, from the front, from the top and from the side.
Goran:-/