DeltaCad Pro Version 7.0 Change of Command

[DavidJ]

I just installed the Ver 7.0 and I think the commands have changed. In the earlier version, control + scroll was the zoom command and just scroll was the up/down command. They have apparently switched. Now, scroll is the zoom command and control + scroll is the up/down. Can I direct the commands back to the ones in Ver 6.0?

DavidJ

[i44troll]

Davidj,

The available options are at....

Options menu/options/mouse wheel options. A dialog box will open to allow you to change the following functions to one of three configurations.

Functions
1) Wheel
2) SHIFT Wheel
3) CONTROL Wheel

Configuration
1) zoom in/out at mouse location
2) pan left/right
3) pan up/down

Hope this helps you

Chris "i44troll"

[DavidJ]

Thank you Thank you Thank you. U R a genius!

DavidJ

--------------edit-------------
"The Boss" says to "i44troll"!

[i44troll]

Ah, shucks!