10-13-2015, 02:08 PM
I stumbled upon the dimensional differences shown on the attached DeltaCad file. I generated this file by first selecting either the 0.0001 or the 3 1/32 measurement units while measuring the various dimensions of object. These dimensions are noted by the underline in red. I then converted the DeltaCad output to its opposite units (0.0001 or 3 1/32).
My question is this: When seeking the most accurate measured dimensions which of the two units (or other units) will give me the best answers?
A follow on question is: Is there a description or code segment say in Visual Basic that would allow me to understand the round offs that must be used when translating from decimal to fractions?
My question is this: When seeking the most accurate measured dimensions which of the two units (or other units) will give me the best answers?
A follow on question is: Is there a description or code segment say in Visual Basic that would allow me to understand the round offs that must be used when translating from decimal to fractions?