Posts: 3
Threads: 1
Joined: Aug 2018
Reputation:
1
I receantly downloaded DeltaCad 8 and when drawing splines it takes a long time to render them. It's so slow they are almost useless. I had the same problem on version 7 which I thought upgrading would help, but it did not. If I remember correctly version 6 had no problems in this area, Is there a setting in the program that can be changed to improve this problem or could it be my computer. Please advise
Posts: 353
Threads: 53
Joined: Dec 2009
Reputation:
3
That's disappointing. On the few occasions I've needed to contact them in the past I've always had a quick response. I don't think it's a very big company - perhaps they're just on vacation. No other suggestions, I'm afraid.
John
Posts: 3
Threads: 1
Joined: Aug 2018
Reputation:
1
I finally stumbled onto an answer for my problem. I am visually impaired so I use Windows Magnifier and found when it was turned off the splines rendered great, almost instantaneously. I got to looking in the magnifier's settings and there was a setting for smoothing edges. When I turned this off the problem went away. I just discovered this a few minutes ago so I hope it continues to work. I hope if anyone else comes upon this problem this will help them.