10-31-2015, 10:07 AM
Hi,
Does anyone have any ideas on the following 2 problems?
I have created a simple cross hatched are within a circle. When I save or export as a ".DWG" and then open the file the circle is fine but the cross hatch is not visible. I believe it is there because when I select in the area it is truing to pick it up.
Also when reopening a DELTA CAD DRAWING file that contains the same cross hatched circle, everything is visible but the tool bar for "line type" no longer will contain the cross hatch option
Thanks, Bill
Does anyone have any ideas on the following 2 problems?
I have created a simple cross hatched are within a circle. When I save or export as a ".DWG" and then open the file the circle is fine but the cross hatch is not visible. I believe it is there because when I select in the area it is truing to pick it up.
Also when reopening a DELTA CAD DRAWING file that contains the same cross hatched circle, everything is visible but the tool bar for "line type" no longer will contain the cross hatch option
Thanks, Bill